Windsock frames to suit 4 foot, 6 foot, 8 foot and 12 foot windsocks. Made in Australia of Stainless Steel.
Commercial Windsock Frames (4, 6, 8, and 12 foot)
$205.00 – $495.00 inc GST
Commercial Windsock Frames designed to fit and support the particular Windsock sizes: 4 Foot. 6 Foot. 8 Foot and 12 Foot.
8 Foot And 12 Foot Commercial Windsock Frames
Commercial Windsock Frames made from 316 grade Stainless Steel. Covered by 25 year warranty.
The Diameter of the opening of an 8 Foot Commercial Windsock Frame is 24 inches (61 cm).
The diameter of the opening of a 12 Foot Commercial Windsock Frame is 36 inches (91.5 cm).
The rim section of the opening is round to ensure that there are no sharp edges that could damage the edges of the wind sock.
Top and bottom Sealed Ball Bearings are used. Lubrication or other attention should never required.
The top bearing is capped with a tight press seal . This offers protection to the top bearing.
The Frame base plate is 10mm plate, with studs at 50 and 80mm spacing. All nuts and washers are supplied for fitting to the “Base Welding Adapter”.
Base Welding Adapter
The Base Welding Adaptor is the black bolt-on attachment in the photo. For use only on the 8 Foot and 12 Foot Commercial Windsock Frames.
Base Welding Adapter is optional and recommended for convenience.
Being non stainless, it is easy to weld to steel pipes or poles. It comes drilled to fit the commercial Windsock Frame with the necessary bolts , nuts and washes.
4 Foot and 6 Foot Commercial Windsock Frames
4 Foot Commercial Windsocks Frames
are Stainless Steel consisting of two parts. A solid Stainless 80 cm supporting rod. A Stainless Swivel Head designed to turn 360 degrees. The ring diameter for this windsock frame is 14 inches (35.5 cm).
The Solid Shaft has 2 holes drilled with the same spacing as a BHP Billiton Star picket (crop dusters use them close to ground level). This shaft has a channel turned towards the top end allowing a grub screw to restrict the swivel head from lifting off in the wind.
As the 4 Foot Windsock is quite light there is single bracing to the ring. The swivel head has a S/S tube with the end closed which allows it to spin on the S/S shaft.
6 Foot Commercial Windsock Frames
are Stainless Steel consisting of two parts. A solid Stainless 80 cm supporting rod. A Stainless Swivel Head designed to turn 360 degrees. The ring diameter for this windsock is 18 inches (46 cm).
It has 2 holes drilled with the same spacing as a BHP Billiton Star picket . This shaft has a channel turned towards the top end allowing a grub screw to restrict the swivel head from lifting off in the wind.
the 6 Foot Swivel Head is doubled braced to support the movement of the 6 Foot windsock. turning 360 degrees. S/S tube over solid S/S shaft.
Use postage calculator to establish delivery cost
|Dimensions||30 × 7 × 7 cm|
|Wind Sock Frame Size|
4 Foot, 6 Foot, 8 Foot, 12 Foot
|Welding Base Adaptor|
No, Yes (+$38.50)